ansys

I have a squre block and inside it there is an sphere. I want to mesh the whole assembly. I can mesh the sphere but when i try to mesh the squre block with the spherical hole it cant mesh and says "it cant select the source and target face". I also tried to devide it into 8 parts. That helped me to mesh the sphere but i cant mesh the squre with spherical hole with that too. So please anyone can help me out.

 Hi

I am doing a simulation using Ansys . I use finite element plane 183 with the generalized plane strain option. The problem is that i am doing something wrong and this option dosn't work .Does anybody knows where i can find an example using generalized plane strain option .I have read the mannual and the example 38 in verification mannual but it did not helped  

I am conducting a senior design project in ANSYS.  I am modeling a folded reinforced concrete plate and have never used ansys before.  Does anyone have any tutorials that involve non-linear analysis?  I am trying to get a force vs. deflection curve and I am having troubles.

 Thanks

Hi everyone,

how can I apply a 'X' amount of heat flus for a specific amount of time? It'll be helpful to include the steps especially for the part on specifying the amount of injection time (say 3 micro seconds)

Thanks!!

hi, can u help me by sending the examples for concreat in ansys because im newly learing it , and how can i deal with soil in ansys my mail is   sun_200549 [at] yahoo.com (sun_200549[at]yahoo[dot]com)

I  need composite pressur vessel analysis, solution manual /procedure

Hi everyone!

I've been trying ansys for a few weeks but in vain. I'm trying to inject a heat source(laser) on a 2D rect plate. I'm not sure on the corrct way to add the boundary conditions. This is what I do:

1. assuming room temp so i added 298K to the bottom, left and right using define loads >add_temp>lines

2.next i inject a heat source say 1000K using define loads>add_temp_on nodes to a few surface center nodes (meaning the top surface still have undefine boundary conditions)  

Hello to everybody,

 Can somebody help me with advice in the next problem : I want to study an dynamic movement of some beams, with rigid body option from ANSYS Classic. I encountered the problem when I want to choose the element type for cilynder. I choose LINK11. But I need to simulate what is happend between the moment when is applied the force on cilynder and imposed lenght of ciclynder after pool.

How I can settup the properties of element LINK11 to satisfy my results.