Ask iMechanica

Hello, Everybody, who is studing reservoir geomechanics,

Hi all

I am trying to use ART plugin for Stent crimping and expansion

Have the stent and artery drawn in abaqus

First question - where can i find the example of  Expansion-Relaxation-Crimping of Stent that Simulia has advertized on its page?

I have made an account and searched but never been able to find it.

Second question coming back to ART plugin - ( I have the art file from abaqus)

Getting this error 

ERROR in job messaging system: Error in connection to analysis

I am trying to apply moving point load on a beam in ABAQUS but not sure which is the best way to do it? Can someone help?

hello sir/madam

i am performing the analysis on biamaterial crack problem on CT specimen for detrmining the plastic zone and i found mises data as i assigning the two sections for these analysis. Now i have found nonsequence order of the mises value due to clashing of mises value at common nodes. so, any one suggest me how to get mises values at each node either in proper order or with geomatrical coordinates. 

I am planning to analyze my Senior Design Project by statically on Abaqus, since I am just an undergraduate student, I am also planning to do this on my new laptop that have;

8+4 GB DDR3 800MHz RAM

Intel i7 4700HQ 3300 MHz Processor

nVidia GeForce GT 750M Graphics

I got Abaqus 6.14 from my school, I tried to make a simple example to test the program is running with no error, finally I have an error with this message;

Hello everyone,

I'm a beginner in Abaqus. I must simulate effect of water stream on thin membrane contactin with ground. Which element type do you suggest? Can STRI65 be a good option?

Thanks in advance

Best

Hi dears colleagues. I'm Phd student. I want to simulate porous material and study its swelling in Ansys.

Could you help me about this subject, my mail; aalil.issam [at] gmail.com

Best regards

Hi,

Hi

I'm a mechanical engineering working on modelling composite in ansys workbench. I have a problem in modelling a composite plate with ACP. To do this, i created a static structural and modeled a surface body of a plate and after applying loads and boundaries, i attached to it an ACP(Pre). The procedures has been done like Tutorial 1 of ACP of ansys workbench 15.

I Have got a problem. I am trying to replicate of finding out "Natural frequency of the I-40 Bridge over Rio grande" results which was done and reported by C.R.Farrar et al. I tried the way he proceeded but not matching with the results I got from Abaqus.