User login


You are here

Import analysis in Abaqus

Hi all,

I am trying to do a multi-step analysis in Abaqus. First 3 steps of the
analysis consist of a single part undergoing a sequence of different
boundary conditions and its behavior is defined by user subroutine UMAT.
The analysis runs perfectly thus far without any errors. Then I am
importing the results of this analysis to a new analysis using *Import,
State=Yes, Update=No options. After importing, I have definition of an
additional part and surface interaction between the new part and the
imported part using *Surface Interaction and *Contact Pair options.
Material properties of the two parts in the new analysis are different.
Then I define the old boundary conditions from the imported analysis as
well as a new step and corresponding boundary conditions. The input file
processor pre.exe runs and does not give any errors or warning
messages. The standard.exe exits with the following error:

Unexpected error 193
1/10/2014 3:56:19 PM
Abaqus Error: The executable C:\SIMULIA\Abaqus\6.11-2\exec\standard.exe
aborted with system error code 5.
Please check the .dat, .msg, and .sta files for error messages if the files
exist.  If there are no error messages and you cannot resolve the problem,
please run the command "abaqus job=support information=support" to report and
save your system information.  Use the same command to run Abaqus that you
used when the problem occurred.  Please contact your local Abaqus support
office and send them the input file, the file support.log which you just
created, the executable name, and the error code.
Abaqus/Analysis exited with errors

The .dat and .sta file are not generated while .msg file is generated but does not have any error or warning messages.

I am not sure about what is causing these errors to occur. Does anyone
know about this? Any help in regard is highly appreciated. 

Thank you in advance!


Free Tags: 
Subscribe to Comments for "Import analysis in Abaqus"

Recent comments

More comments


Subscribe to Syndicate