Ask iMechanica

Hi,

Does anyone know how to convert the result of Abaqus/Explicit from .sel file to .fil.

I run a analysis and generate the .sel file. Then, I use commond:

abaqus job=[file name] convert=all

The convert process is completed but i cannot file any .fil file. Does anyone know the reason?

Thank youv very much

Alex

These days I've been applying oneself to implement the Chaboche viscoplastic model in ABAQUS user-subroutine for simulating the cyclic loading in single crystals.

The procedure can easily get out. I'm not sure about the problem, the deduction of Jacobian, the convergence? 

Btw, I know there is free subroutine for crystal plasticity by Huang YG. I wonder if the UMAT routine for chaboche model is available, then I can generalize it to fit for my case.

Hello lads,

 Any chance, s.o knows how to :

-get the stress distribution across a line in a 3D model using ANSYS workbench ?? That be grand ! Cheers

Fracture Mechanics,

CAE

 FEA

Crash Analysis

1.Choosing
the correct material properties (SOLID,SHELL etc.) and correct
method( Prony Series or Generalized Maxwell for
viscoelastic)

2.Creating a cylindirical model as an example
and than creating the orginial model as a representation of the soft
tissue(in this case the tissue must be some living organ ex:liver )

3.By
using the contact modeling (I learned that it requires to have some
detailed experience in writing subroutine) dividing the material into

Hi everyone:

can anybody introduce me to a paper in which the strain in the soft tissue in free swelling problem is plotted against the position, over time?

Thank you very much,

Alireza

hi, i'm baie ..i need ABAQUS/CAE software..is't anybody can give me the software..urgently. thankyou.

I am trying to create a model of a travelling wave ultrasonic motor and have found it difficult to find out how to apply the natural frequency of a steel ring to it at two seperate points, seperated by an angle of about 11 degrees. Any ideas or help would be appreciated.

Dear, I use the abaqus present , how can apply a tightening torque between an implant (screw) and the bone with abaqus......... thank you ¶