Could you tell me how to define inflow and outflow eulerian boundary in ALE? MY ERROR IS "An Eulerian boundary region cannot overlap a sliding boundary region"
Defined in the first interface surface, and then modify the inp file, change to add
REGION TYPE = EULERIAN
*SURFACE, NAME=SURF1, REGION TYPE=SLIDING
TOP,S4
*SURFACE, NAME=EULER1, REGION TYPE=EULERIAN
EULER1,S3
Then, I go on the File/Import/Model...inp.file - when he fined warning
WARNING: The following keywords/parameters are not yet supported by the input file reader:
---------------------------------------------------------------------------------
*BOUNDARY, REGIONTYPE
*SURFACE, REGIONTYPE
The model has been imported from an input file.
Please scroll up to check for error and warning messages.
I m see Abaqus Example Problems Manual
ale_flatrolling_inletoutlet.inp
I go on the File/Import/Model...ale_flatrolling_inletoutlet.inp - and I see next WARNING, too.
WARNING: The following keywords/parameters are not yet supported by the input file reader:
---------------------------------------------------------------------------------
*BOUNDARY, REGIONTYPE
*ELFILE
*FILEOUTPUT
*NODEFILE
*STEADYSTATECRITERIA
*STEADYSTATEDETECTION
*SURFACE, REGIONTYPE
The model "ale_flatrolling_inletoutlet" has been imported from an input file.
Please scroll up to check for error and warning messages.
I DON`T NOW, WHAT IS THE PROBLEM. Could you tell me how to define EULERIAN SURFACE, AND EULERIAN BONDARY CONDITION.
ale_flatrolling_inletoutlet.inp
I go on the File/Import/Model...ale_flatrolling_inletoutlet.inp - and I see next WARNING, too.
WARNING: The following keywords/parameters are not yet supported by the input file reader:
---------------------------------------------------------------------------------
*BOUNDARY, REGIONTYPE
*ELFILE
*FILEOUTPUT
*NODEFILE
*STEADYSTATECRITERIA
*STEADYSTATEDETECTION
*SURFACE, REGIONTYPE
The model "ale_flatrolling_inletoutlet" has been imported from an input file.
Please scroll up to check for error and warning messages.
I DON`T NOW, WHAT IS THE PROBLEM. Could you tell me how to define EULERIAN SURFACE, AND EULERIAN BONDARY CONDITION.
Thank you so much!
2D orthogonal machining in abaqus
I am having the same problem.
I am simulating 2D orthogonal machining in abaqus and I wish to set my workpiece mesh as eulerian. But the keyword "Region type" is not being identified by abaqus!
Someone plz answer!
hi
dear krishna
i have the same problem
i want to simulate 2D orthogonal machining using ALE adaptive mesh and mesh constrains with abaqus. but outflow and inflow of mesh must be eulerian. i dont know how to change lagrangian(default) to eulerian. plz help me.
hi, this might be a
hi,
this might be a little bit old post, anyway ill post it since i also need some help,
regarding your problem ahead, it is because ABAQUS cae still not supporting keyword for REGION TYPE, and a lot more.
remeber when you set your surface region type to eulerian, you have constraint it mesh otherwise it wont work.
incase you have sucessfully simulate it can you share it with me? i currently have problem in constraining the mesh(in the hole region) what i want is
the material flow but the mesh by the pin (hole) not move. but it always said that mesh contraint angle exceed the critical.. something like that.
here is my email if you could help me
kairi_kairu [at] hotmail.com
thanks