I am trying to perform simulation of Crushable Foam Plasticity model. However, I am getting convergence error
***NOTE: THE SOLUTION APPEARS TO BE DIVERGING. CONVERGENCE IS JUDGED UNLIKELY.
***ERROR: TOO MANY ATTEMPTS MADE FOR THIS INCREMENT
Can someone please help. I have attached the image of Abaqus input data.
Thanks a lot in Advance.
Topic 1: Rank top ten severe accidents in energy
sector
1.
Gulf
of Mexico:
The accident
was caused by gas release and subsequent explosion. There were 11 people died.
The accident involved a well integrity failure followed by a loss of
hydrostatic control of the well. BOP emergency functions failed to seal the
well after the initial explosions.
2.
Fukushima
Daiichi nuclear disaster:
The Applied Mechanics Division seeks nominations for the awards listed below. All awards are international. Each nomination should include a nomination form and 4-5 letters of support, as described at http://www.asme.org/Governance/Honors/SocietyAwards/Nominate.cfm.
Installing
solar panels on rooftops are obviously a high risk activity. There are a number
of hazards such as working at heights which could lead to falls from heights or
falling objects. Also slippery roof surfaces, damaged roofs, electrical
discharge from uninstalled panels, electrical fitting and equipments are all
potential hazards. All these, when not properly controlled could lead to
undesired conquences.
Here is our recent paper published in Journal of Applied Physics
Title: "Anomalous phonon behavior of carbon nanotubes: First-order influence of external load"
Authors: Amin Aghaei, Kaushik Dayal, Ryan S Elliott
Abstract:
Safety Engineering and Risk Management Debate 2012
Discussion Topic 9: Safety and risk management in oil and gas industry
Safety Engineering and Risk Management Debate 2012
Discussion Topic 8: subsea integrity and reliability management
Safety Engineering and Risk Management Debate 2012
Discussion Topic 7: Discuss safety considerations in wave energy system.
