Submitted by mahinryan on Fri, 02/03/2012 - 10:55 research how to mesh two sucessive volumes with different meshing i've modeled a column as a volume i need a closer or finer mesh near the junction of beam anyone pls guide me on this issue??? Lihua Jin MPC You may consider the following two ways: 1. You can use different mshing in different parts, and then use multi-point constraint to constrain the displacement in the connecting region of different meshes. 2. You can use bias meshing in the connecting region. Log in or register to post comments Mon, 02/06/2012 - 19:54 Permalink mahinryan In reply to MPC by Lihua Jin Madam,Thank you very much, Madam,Thank you very much, your reply. How to apply the Reversal load steps using Ansys, Mono tonic load application of the load steps not a problem & performance also I am getting as per the laboratory results crack patens Thanks & regards s.raja Log in or register to post comments Wed, 03/14/2012 - 05:08 Permalink Log in or register to post comments3269 views
Lihua Jin MPC You may consider the following two ways: 1. You can use different mshing in different parts, and then use multi-point constraint to constrain the displacement in the connecting region of different meshes. 2. You can use bias meshing in the connecting region. Log in or register to post comments Mon, 02/06/2012 - 19:54 Permalink
mahinryan In reply to MPC by Lihua Jin Madam,Thank you very much, Madam,Thank you very much, your reply. How to apply the Reversal load steps using Ansys, Mono tonic load application of the load steps not a problem & performance also I am getting as per the laboratory results crack patens Thanks & regards s.raja Log in or register to post comments Wed, 03/14/2012 - 05:08 Permalink
MPC
You may consider the following two ways:
1. You can use different mshing in different parts, and then use multi-point constraint to constrain the displacement in the connecting region of different meshes.
2. You can use bias meshing in the connecting region.
In reply to MPC by Lihua Jin
Madam,Thank you very much,
Madam,Thank you very much, your reply.
How to apply the Reversal load steps using Ansys,
Mono tonic load application of the load steps not a problem & performance also I am getting as per the laboratory results crack patens
Thanks & regards
s.raja