Submitted by hossein_r on Thu, 07/14/2011 - 16:59 software Hi everone I want to molel an implant. I want to create a bolt in Ansys or abaqus. but I cant create its threades. can you help me ? thanks mobinya1 Hi Hossein, Did you have Hi Hossein, Did you have any progress in developing your model? I should do something the same, and I have problems defining threads in abaqus. Log in to post comments Fri, 01/06/2012 - 05:53 Permalink king_man In reply to Hi Hossein, Did you have by mobinya1 HI mobinya1 you can HI mobinya1 you can create the threads using Revolve. just draw a cross section of thread and use Revolve and enter the angle and pitch. Hossein Log in to post comments Sun, 06/09/2013 - 21:16 Permalink Log in to post comments14114 views
mobinya1 Hi Hossein, Did you have Hi Hossein, Did you have any progress in developing your model? I should do something the same, and I have problems defining threads in abaqus. Log in to post comments Fri, 01/06/2012 - 05:53 Permalink
king_man In reply to Hi Hossein, Did you have by mobinya1 HI mobinya1 you can HI mobinya1 you can create the threads using Revolve. just draw a cross section of thread and use Revolve and enter the angle and pitch. Hossein Log in to post comments Sun, 06/09/2013 - 21:16 Permalink
Hi Hossein, Did you have
Hi Hossein,
Did you have any progress in developing your model? I should do something the same, and I have problems defining threads in abaqus.
In reply to Hi Hossein, Did you have by mobinya1
HI mobinya1 you can
HI mobinya1
you can create the threads using Revolve. just draw a cross section of thread and use Revolve and enter the angle and pitch.
Hossein