hey friends,
i am using abaqus 6.9-3 on win7. i need to use *nodefile command in the input file. But when i run the file through GUI it says:
WARNING: The following keywords/parameters are not yet supported by the input file reader:
---------------------------------------------------------------------------------
*BOUNDARY, LOADCASE
*NODEFILE
Please help me.....
also i wud like info on running jobs through command prompt. I have no idea about this.
I have added commands directory to system variables......
Thanks in advance....
hi,i am performing fem
hi,i am performing fem simulation on abaqus 6.10 on impact on composite plates.error shown :-
ELELMENT 3501 INSTANCE PLATE MISSING A PROPERTY DEFINITION.CHECK ELEMENT SET AND ELEMENT DEFINITION
In reply to hi,i am performing fem by TANZEEM UL HASAN
Section assignment
Some of your created parts have not been assigned with section definitions (available in the Property module).
regards
asim
Dear sshradhe, some of
Dear sshradhe,
some of the keywords written on the input file of Abaqus (*.inp) are not supported in Abaqus CAE. You can refer to the Abaqus keywords manual for further details. Regarding your question on how to run an abaqus analysis in the command prompt window, follow these steps :
1st.Open a command prompt window
2nd. find the path of the folder which contain your *.inp file.
3rd. type :" abaqus job=test" , without the quotes (where test is the name of your input file)
Good Luck,
Ilias Zilakos