Skip to main content

Simulation of a cylinder into a cubic and interaction betwwen them by ABAQUS

Submitted by R. Hasanpour on
education

Hi



I want to simulate a cylinder into a cubic and interaction between them when cubic is subjected to vertical pressure.

I simulated it with ABAQUS, and I run it successfuly. But there was no interaction between cubic and cylinder, and deformations in cubic because of vertical pressure did not affect on cylinder. Do anyone have any solution for this problem?



With regards

The images about model are attached.

Attachment Size
1.JPG 98.2 KB
2.JPG 49.72 KB
3.JPG 93.84 KB
asimkm

In the interaction module you should create a surface to surface contact(inner surface of the cavity to the outer surface of the cylinder) with the normal hard contact property. Also a general contact should prevent penetration of cuboid into the cylinder.

 regards

asim

Sat, 08/27/2011 - 14:24 Permalink