Hello ! I'm a beginner in Abaqus and for that I've tried to follow this tutorialhttp://fliiby.com/file/831535/i3rkmyhurs.html .
I was all ok until I tried to make the mesh (chapter 3.7.2 in tutorial). It said that they are parts of the assemby that are too complex to be meshed with those mesh settings.
The problematic zone is this:
http://dl.fisier.ro/files/fg5km1bnghh254k/1.JPG.html from a far away point,
http://dl.fisier.ro/files/5k75edol71l135e/2.JPG.html from a close point,
http://dl.fisier.ro/files/5e44hm5or1mkdhh/3.JPG.html from a more close point,
http://dl.fisier.ro/files/14je3hpgb1inldj/4.JPG.html from which it can be seen morea easily the problematic zone .
From my observation, even following the instruction given in tutorial, between the solder-1 and the cap, the is a empty space (they are not merged as it must normaly be).
I've tried to start over the entire execise, and, that empty spare appeared again.
Could anybody give me some advices ?
I use Abaqus 6.9 . Here http://dl.fisier.ro/files/3ncmfplel2...model.zip.html is my model .
Thanks, and have a nice day !
Later edit. I tried to
Later edit. I tried to understand what was happened, and I concluded that de geometry of the model is correct (and the space that I was talking about earlier doesn't exist).
Supposind that de tutorial (until the mesh partitioning stage is corect), how could I partition the last portion of the assembly (that colored in orange in the picture posted earlier) ?
P.S. I know that green part (when we are partitioning module) means part corectly partitioned, but I don't clearly undersand what means orange and red ones.