In ANSYS Gives following Error......
Error...."Use of the M switch is no longer recommended for normal ANSYS use. ANSYS now dyanamically allocates memory as needed. Only use the -M switch if you are certain that you need to do so".and suddenly ANSYS window close automatically.....
please give the suggestions
ANSYS
ANSYS
no need maximum memory
It is not necessary to allocate a maxmum memory when you run the softaware. ANSYS can control it by itself. So turn it off.
In reply to no need maximum memory by ChangyongCao
How to turn it off?
hii changyongcao
How to turn it off?