Submitted by M Vettorato on Thu, 12/10/2009 - 10:29 education How can you apply a pressure, not normal to a angled face in a 3D model in Abaqus? Is that possible? See sketch: P --> / Regards yawlou perhaps use normal and tangential components It might be that you need to apply components of the pressure to get the desired result. In other words normal components and tangential components. The net result of these components should be selected to get the result that you seek. regards, Louie Log in or register to post comments Thu, 12/10/2009 - 18:06 Permalink Log in or register to post comments2471 views
yawlou perhaps use normal and tangential components It might be that you need to apply components of the pressure to get the desired result. In other words normal components and tangential components. The net result of these components should be selected to get the result that you seek. regards, Louie Log in or register to post comments Thu, 12/10/2009 - 18:06 Permalink
perhaps use normal and tangential components
It might be that you need to apply components of the pressure to get the desired result. In other words normal components and tangential components. The net result of these components should be selected to get the result that you seek.
regards,
Louie