Blog posts

In Abaqus .inp or Abaqus/CAE, are there mesh generation commands similar to ANSYS commands FILL, NGEN, and EGEN used to geneate nodes (between keypoints) and elements ?

Brown University established a School of Engineering on July 1, 2010 and is beginning a major hiring initiative to fill multiple openings.  As part of this initiative, the School is seeking to fill a position in Solid Mechanics at any academic level to start in July 2011.

For the most up to date corrections to the book, go to http://forum.cadec-online.com/viewtopic.php?f=9&t=34

For the most up to date ERRATA, go to http://www.mae.wvu.edu/barbero/feacm/errata_feacm.htm 

i am working on the stability analysis of cantilever shaft disk 9rotor) systems. i am a beginner in this work. can any one please suggest any books or papers which can help me in my work. i will be grateful to you.

Adhesive bonding is contemplated as an alternative method to mechanical fastening for joining composite aerostructures.

Ongoing research in this area is focused on the development of new bonding techniques and joining elements. In this

article, the mechanical performance of the novel noncrimp fabric (NCF) H-shaped adhesively bonded joints subjected to

tension, shear and four-point bending loading conditions was investigated by both experimental tests and numerical

Can anyone guide me how to get crosshead speed range equal to or greater than 1:3000 in a motorized electromechanical material testing machine? The load capacity should remain same even at lowest speed.