Blog posts

I wnat simulat rollong process. Mteral deformation is simulated by FEM and i want simujlate microstructure evolution by KMC method. Do any one have experience in this field (coupling FEM and KMC) ?

I want simulat micro strucure evolution in metal fromind, e.g. rolling. To capture grain growth or refinement, i use MC method and rolling process simulate by FEM method (ABAQUS). Do any one have experience in this field?

Hi all,

Just thought that the following paper archived at the arXiv yesterday could be of general interest to any mechanician:

Xingyu Zhang, Matthew Tomes, Tal Carmon (2011) "Precession optomechanics," arXiv:1104.4839 [^]

The fig. 1 in it makes the matter conceptually so simple that the paper can be recommended to any mechanician for his general reading, and not only to a specialist in the field.

--Ajit

[E&OE]

The 48th Annual Technical Meeting of Society of Engineering Sciences will be held October 12-14, 2011 at Northwestern University Evanston, Illinois 60208, USA. 　The meeting will have 43 symposia covering a wide range of topics in engineering sciences.　 To learn more about the conference and submit an abstract, please check the conference webpage www.ses2011.org.

 An analytical model is developed to study the coupling effects in
cord-rubber composite materials. The analytical model takes into account
the mismatch of stiffness between the cords and the rubber matrix
material, and the twist-extension coupling. The transverse deformation,
i.e., normal to the cords direction is based on the normal modes of a
special system which describes the orthotropic and the coupling
behaviour of cord-rubber composites. The equations of motion for the
cord-composite plates are derived using the principle of virtual work.
Results of deformation and stresses are obtained for some typical
cord-rubber composite plates and are compared to the existing solutions.
The results presented illustrate that the coupling effects are

Hi

 The main purpose of this paper is to complete the works presented by
Andrieux and Varé (2002) and El Arem et al. (2003) by taking into
account the effects of shearing in the constitutive equations of a beam
cracked section in bi-axial flexure. The paper describes the derivation
of a lumped cracked beam model from the three-dimensional formulation of
the general problem of elasticity with unilateral contact conditions on
the crack lips. Properties of the potential energy and convex analysis
are used to reduce the three-dimensional computations needed for the
model identification, and to derive the final form of the elastic energy
that determines the nonlinear constitutive equations of the cracked