Submitted by arunbabu on Mon, 12/01/2008 - 06:20 research hello every one is it possible to make a cantilever whose natural frequnecy is less than 1Hz. if yes what will be its dimensions if the youngs moduless is taken as 2200 n/mm^2 ? what will be the minimum resonent frequency that i can reached with? Wenbin Yu Depending on which mode you Depending on which mode you are looking at. If it is the bending mode, then you also need to design your cantilevel for the mass per unit length, length and bending stiffness. These three parameters all affect your natural frequenies. Log in or register to post comments Wed, 04/29/2009 - 17:21 Permalink Log in or register to post comments2748 views
Wenbin Yu Depending on which mode you Depending on which mode you are looking at. If it is the bending mode, then you also need to design your cantilevel for the mass per unit length, length and bending stiffness. These three parameters all affect your natural frequenies. Log in or register to post comments Wed, 04/29/2009 - 17:21 Permalink
Depending on which mode you
Depending on which mode you are looking at. If it is the bending mode, then you also need to design your cantilevel for the mass per unit length, length and bending stiffness. These three parameters all affect your natural frequenies.