Submitted by kaslantas on Wed, 04/23/2008 - 16:05 research Dear friends, I would like to apply angular velocity on a gear in ANSYS. Do you have any idea? Is there any firend having such example? If yes, can you share? thanks Huapei Wan Kaslantas, You may Kaslantas, You may describe your question in more detail. However, I think one of the strategy is to use APDL to apply translational velocity at every node according to the radius from rotational center. Hope this helps Huapei Log in or register to post comments Fri, 04/25/2008 - 21:27 Permalink TrongDaick05 ellip contact gear I want simulation ellip contact of two surface gear while mesh of pair helical gear by Ansys. I hope you can help me Thank you very much ! Log in or register to post comments Tue, 06/14/2011 - 18:13 Permalink Log in or register to post comments11845 views
Huapei Wan Kaslantas, You may Kaslantas, You may describe your question in more detail. However, I think one of the strategy is to use APDL to apply translational velocity at every node according to the radius from rotational center. Hope this helps Huapei Log in or register to post comments Fri, 04/25/2008 - 21:27 Permalink
TrongDaick05 ellip contact gear I want simulation ellip contact of two surface gear while mesh of pair helical gear by Ansys. I hope you can help me Thank you very much ! Log in or register to post comments Tue, 06/14/2011 - 18:13 Permalink
Kaslantas, You may
Kaslantas,
You may describe your question in more detail. However, I think one of the strategy is to use APDL to apply translational velocity at every node according to the radius from rotational center.
Hope this helps
Huapei
ellip contact gear
I want simulation ellip contact of two surface gear while mesh of pair helical gear by Ansys. I hope you can help me
Thank you very much !