User login

Navigation

You are here

XFEM for rock in ABAQUS

Hi

I tried to simulating crack propagation with XFEM method  in porous media (rock),  but got error code 144 (like this error" the executable C:\SIMULIA\Abaqus\6.9-1\exec\standard.exe aborted with system error code 144. Please check the .dat, .msg, and .sta files for error messages if the files exist. If there are no error messages and you cannot resolve the problem, please run the command" )

I think abaqus 6.11 can't simulating crock propagation with XFEM method  in porous media , is it true?

thank you very much for your attention 

Comments

Frank Richter's picture

Hello

 

errors 14x are not specific to XFEM. It has been discussed in the ABAQUS mailing list
http://groups.yahoo.com/neo/groups/Abaqus/info

The error is quite common when using subroutines and was reported also in one case when using only standard commands.

My advice is to modify the initial, maximum and minimum time increment. Try increasing and decreasing.

 

Good luck

Frank

 

 

------------------------------------------
Ruhr-University
Bochum
Germany

Dear Frank 

I tried it again with another version of abaqus (6.13) and get error that abaqus cant analysis pore pressure with XFEM .

that error :  A xfem analysis with pore pressure degrees of freedom is not supported 

thanks :) 

Hello,

Did you solve the error: "A xfem analysis with pore pressure degrees of freedom is not supported "?

I have exactly the same problem and I have no idea how to solve it.

Thank you in advance.

 

Juanjo.

Subscribe to Comments for "XFEM for rock in ABAQUS"

More comments

Syndicate

Subscribe to Syndicate