Hello,
I'm trying to run an analysis on Zencrack on a CTS (compact tension specimen) with a through crack block to evaluate stress intensity factors. I believe there's something going on but I surelly can't find what's missing. This is the message from my report file :
***WARNING
Expected output file from an Ansys solid model run does not exist:
fendar.elex
***WARNING
Expected output file from an Ansys solid model run does not exist:
fendar.xyzx
Check the Ansys output for errors: fendar-zcr.out
***ERROR 3136
There were 1 errors processing the uncracked Ansys mesh.
For details see file c:\users\paulo\desktop\tese\ansys\malha_teste\malha.ansout.
and this is the warning on the fendar-zcr,out file
*** WARNING *** CP = 0.984 TIME= 16:11:13
Display device has not yet been specified with /SHOW. Command ignored.
CONSTRAINT AT ALL PICKED AREAS
LOAD LABELS = UX UY UZ
VALUES = 0.0000 0.0000
SURFACE LOAD ON ALL PICKED AREAS
LOAD KEY =1 LOAD LABEL = PRES
VALUES = -0.30000E+08 0.0000
Can someone give me a tip?
I think maybe constraints may not be well defined