combining Abaqus/Standard and Abaqus/Explicit?

How can I run an analysis that starts in Abaqus/Standard and can be continued in Abaqus/Explicit? Does Abaqus automatically take care of data exchange between them or it should be manual. In other words, can I define step1 in a model run by Abaqus/Standard then immediately running step2 under Abaqus/Explicit?

Thanks,
Ahmad Falahatpisheh
PhD student of Mechanical and Aerospace Engineering
Edwards Lifesciences Center for Advanced Cardiovascular Technology
2141 Engineering Hall
University of California, Irvine

 


Hi, Never tried using

Hi,

Never tried using abq/standard and abq/explicit consecutively, but here is what you are looking for:

http://www.simulia.com/products/abaqus_explicit.html

Hoping that it will help.  Found the link by using google keywords "abaqus standard and explicit consecutively" . Other results are also available, so check it out...

Regards...


Andras Nelhiebel's picture

Possible, but you should be careful

Hello,

 I have done it, it is possible, but you should be careful. Some things cannot be imported from Standard to Explicit and vice versa. Some things (e.g. BC, contacts) should be new defined. The Users Manual gives you al the details you need. It is often used for metal forming (explicit) with springback (implicit).

Best regards,

Andras


transfer results btw abaqus std& explicit

hi,

 Refer to section 3.12 Transferring results between Abaqus/Standard and Abaqus/Explicit in abaqus verification manual.

U.N.S. ROHITH