Using the display group

YiPan — Fri, 18 Dec 2009 12:14:46 -0500

Using the display group tool (view -> toolbars -> display group)

to remove the cell on the left, then pick the point of interest.

Picking a node within a 3D Solid Volume

looyong — Wed, 16 Dec 2009 14:18:32 -0500

hi all,

I have a solid 3D part made of concrete. I would need
the results of a few points inside the concrete. However, I realised it
was not easy to pick them when doing a Set because the nodes are hidden
(they are not on the surface. I have 1) partition my model exactly at
the points when I need to pick 2) i name the points as datum points.

Using the CAE interface, how can i pick this nodes? I have attached a pic for better understanding. Can anyone please advise?

Thank you.

iMechanica - Picking a node within a 3D Solid Volume - Comments

Using the display group

Picking a node within a 3D Solid Volume